Sealing a window frame with Silico One RTV silicone sealant

A good silicone joint is mostly about preparation and a steady hand. Whether you are sealing a window frame, a bathroom or a kitchen worktop, these steps will help you get a neat, watertight seal with Silico One RTV silicone sealant.

What you need

  • Silico One RTV Silicone Sealant — 310 ml cartridge with a caulking gun, 600 ml sausage pack with a sausage gun, or the 50 ml tube for small jobs.
  • A sharp utility knife.
  • Masking tape (for a sharp, straight edge).
  • A clean cloth and a scraper to remove old sealant.
  • A smoothing tool or a gloved finger to finish the bead.

Step 1: Prepare the joint

Silicone bonds best to surfaces that are clean, dry and free of dust, oil, grease and old sealant. Scrape out any old silicone completely, wipe the joint clean and let it dry. Applying new sealant over old or dirty sealant is the most common reason a joint fails early.

Step 2: Mask the edges

Run masking tape along both sides of the joint, leaving a gap the width you want the finished bead to be. This gives a sharp, professional line and keeps sealant off the surrounding surface.

Step 3: Cut the nozzle

Cut the nozzle at an angle, a little smaller than the width of the joint — you can always cut more off, but you cannot add it back. Load the cartridge into the caulking gun (or the foil pack into a sausage gun). For the 50 ml tube, simply screw on the applicator nozzle.

Step 4: Run the bead

Hold the gun at a steady angle and squeeze with even pressure, pushing the sealant into the joint as you move along. Work in one continuous pass where you can; stopping and starting leaves lumps and weak spots.

Step 5: Smooth and remove the tape

Smooth the bead straight away, before a skin forms, pressing it gently into the joint so it fills it completely. Then pull the masking tape off at an angle, away from the joint, while the sealant is still soft.

Step 6: Leave it to cure

RTV silicone cures at room temperature by reacting with moisture in the air. Leave the joint undisturbed and keep it away from water while it cures. Always follow the instructions printed on the pack.

Tips for a better result

  • Work in a well-ventilated area.
  • Test first on natural stone, mirrors and sensitive metals.
  • Keep a cloth handy to wipe the nozzle between runs.
  • Store opened packs with the cap or nozzle sealed, in a cool, dry place out of direct sunlight.

Have a question about a particular job? Contact our team — we are happy to help you choose the right product and pack size.

Leave a Reply

Your email address will not be published. Required fields are marked *